Edge-weaving Mechanism-configuration requirements for weaving edges

(1) Weaving edge is divided into left weaving edge and right weaving edge, configuration requirements are different, should be handled differently.

(2) the choice of metal wire used in weaving edge: should choose the higher tensile strength of stainless steel wire is appropriate. Silk diameter size should be the same, not allowed to mix thick and thin. Weaving edge wire diameter should be larger than the diameter of the metal wire, generally large (1 ~ 2) silk number.

(3) Selection of the number of wire roots of the weaving edge: the left weaving edge is (6~10) roots, and the right weaving edge is (10~14) roots. The number of weaving edge roots for the even number, not allowed to use the odd number.

(4) Weaving edge wire arrangement density: weaving edge arrangement density (through the wheel density) than the density of woven wire mesh at least half as thin, the left weaving edge than the right weaving edge of the arrangement of the density of some thin.

(5) weaving edge arrangement density is reasonable to determine the principle of weaving edge fabrics should be less than the weft force of the metal mesh, the weaving position is usually more than the metal mesh weaving position in front of the weaving mouth.

(6) The distance of the weaving edge from the edge of the net: the left weaving edge is left (8~10) mm, the right weaving edge is left (10~20) mm, the distance is too big, it is easy to cause a waste of silk material.

(7) Left-hand side wires can be threaded onto the main heald or onto the left-hand side heald. Right-hand side wires must be threaded onto the right-hand side heald, not into the main heald.

(8) Plain weaving edge cams must be used for plain weaving; cams for twill weaving edges must be used for twill weaving; plain weaving edge cams must be used for satin weaving.