Installation Height and Usage Principle of the Stopping Masts

1. The mounting height of the warp stopper bar 

The upper edge of the warp stopper bar leaves 

the upper end of the warp stop sheet (10~15) mm 

is appropriate. Changing the mounting height of 

the warp stop sheet can change the relative height 

of the warp stop sheet in the warp stop sheet. The 

relative height of the warp stop sheet in the warp 

stop sheet can also be changed by changing the 

height of the warp stopper rollers (rear beam). If 

the warp stopper rollers are elevated, the relative 

height of the warp stop sheet will be reduced, and 

vice versa.

2. The warp stop motions are fixed to the bracket 

which is insulated from the machine body. The core 

plate of the motions is connected to the warp stop 

conductor (12V low voltage conductor). The warp 

stop motions are connected to the warp stop wires 

(12V low voltage wires). When the core plate of the 

warp stop motions is not in contact with the warp 

stop motions, the loom rotates normally. When the 

warp breaks, the drop wire falls down, and then the 

drop wire contacts the core plate of the warp stop bar, 

causing the warp stop circuit to conduct, causing the 

magnetic starter motor to stop, and the weaving 

machine to stop.